NF WAVE FACTORY WF1967, Instruction Manual (Operations, Page: 46 / 330

3.2 I/O Terminals
WF1967/WF1968
3-16
Figure 3-5 Multi-I/O connector pin configuration diagram
Table 3-2 Multi-I/O connector pin assign
Pin No. I/O
Sweep Oscillation
Mode
Sequence Oscillation Mode
Optional cable color
and marking(s)
1 Output Not in use Step synchronization code D0(LSB) Light brown and Black
2 Output Not in use Step synchronization code D1 Light brown and Red
3 Output Not in use Step synchronization code D2 Yellow and Black
4 Output Not in use Step synchronization code D3(MSB) Yellow and Red
5 Output Not in use Not in use Bright green and Black
6 GND - - Bright green and Red
7 GND - - Gray and Black
8 GND - - Gray and Red
9 (Reserved) Do not connect anything. Do not connect anything. White and Black
10 GND - - White and Red
11 Input Not in use Event Branch Light-brown and Black
Black
12 Input Hold/Resume Hold/Resume Light-brown and Red Red
13 Input Stop Stop Yellow and Black Black
14 Input Start Start or State branch Yellow and Red Red
15 Input Not in use Not in use Bright green and Black
Black
Shell - - - Bright green and Red Red
Caution: Pin no. 9 is set to +5V for manufacturing tests. It is not intended for use by end users. Do not
connect it to anything as it may cause the product to become unstable.
Check
To prevent malfunction due to exogenous noise when not using the multi-I/O
connector, it is recommended that the control input be set to prohibited.

P.4-81