NF WAVE FACTORY WF1967, Instruction Manual (Operations, Page: 288 / 330

16 List of Initial Settings
WF1967/WF1968 16-2
When initialization([Reset]) is performed on the Utility screen , settings are initialized as follows. These
items are also stored in the setting memory (except for output on/off setting).
The arbitration memory, the setting memory, the user-defined unit setting, the output setting at power-on,
the remote setting, and the panel operation settings are not initialized. The user-defined unit setting is not
initialized. However, it is stored in the setting memory.

Equipment state
Operation mode Oscillator

Main output setting
Oscillation mode Continuous oscillation
Waveform Sine wave
Polarity and amplitude range Normal, ±FS
Frequency 1kHz
Amplitude 0.1Vp-p
DC offset 0V
Range Auto
Load impedance Open
Phase 0°
Output Off
Noise bandwidth 30MHz

Waveform
Square wave duty Standard range, 50%
Pulse wave duty 50%
Pulse wave leading/trailing time
1μs
Lamp wave symmetry 50%

Sub output setting
Synchronization/Sub output Reference phase synchronization
Sub waveform sine
Sub frequency 1kHz
Sub phase 0°
Sub noise bandwidth 30MHz
Sub amplitude 0.1Vp-p
Sub offset 0V

Modulation
Modulation type FM
FM peak deviation 100Hz
FSK hop frequency 1.1kHz
PM peak deviation 90°
PSK deviation 90°
AM modulation depth 50%
DC offset modulation peak deviation 0.1V
PWM peak deviation 10%
Modulation source Internal, sine wave, 100Hz
FSK/PSK external modulation input polarity Positive
Synchronization/sub-output Internal modulation synchronization