NF WAVE FACTORY WF1967, Instruction Manual (Operations, Page: 256 / 330

12.1 About User-defined Unit
WF1967/WF1968 12-2
12.1 About User-defined Unit
For example, you can set the frequency in units of rpm (number of rotations per minute) instead of Hz.
You can set a value converted to the mechanical deviation quantity or a value converted to the output
voltage after the power amplifier output instead of voltage.
Defining these mutual conversion formulas enables you to use them like the usual units. In this product,
these units are called "user-defined unit."
The user-defined unit can be used for the following six parameters:
Frequency, period, amplitude, DC offset, phase, and duty
12.2 Display and Setting in User-defined Unit
When an input field for each parameter
opens, you can change the unit by putting
the cursor on the unit at the right end and
using the up/down arrow key or the modify
knob. The unit name displayed here can be
set arbitrarily. Only the display unit is
changed without changing the actual output
value, when the unit is changed.
Select the
user-defined unit