NF WAVE FACTORY WF1967, Instruction Manual (Operations, Page: 136 / 330

4.8 Setting and Operation of Sweep
WF1967/WF1968 4-86
DC offset modulation is canceled (modulation function turned off) when DC offset sweep is
specified.
d) Items necessary for DC offset sweep
Set the following items on the second page of the setting screen. The DC offset setting on first page
of the setting screen becomes invalid, and the current DC offset is displayed.
• Start DC offset [Start]
• Stop DC offset [Stop]
• Sweep time [Time]
Time to change from the starting DC offset to the stop DC offset.

P.4-74
• Sweep Mode [SwpMode]
Select from continuous, single, or gated single.

P.4-75
• Sweep function [SwpFctn]
Select from one-way, shuttle.

P.4-75
It is possible to set with center DC offset [Center] / span DC offset [Span], instead of start DC offset
/ stop DC offset.

P.4-74
When sweep mode is single or gated single, it is necessary to set the trigger condition [Trig].

P.4-77
Set the following items as needed:
• Marker DC offset [Marker] (second page of the setting screen)

P.4-79
• Stop level [StpLvl] (second page of the setting screen)

P.4-76
The setting used for gated single sweep only.
• Oscillation stop unit of the gated single sweep [OscStop] (second page of the setting screen)

P.4-76
The setting used for gated single sweep only.
• Synchronization/sub output selection [SubOut] (third page of the setting screen)

P.4-79
4.8.8 Setting Duty Sweep
For the sweep setting screen and the common operation method, please refer to P.4-71, P.4-74
a) Duty sweep example
Examples of a continuous sweep and linear shuttle.
Shuttle sweep
Sweep value
Start value
Sweep time
Sweep time
Stop value
Output signal