NF WAVE FACTORY WF1967, Instruction Manual (Operations, Page: 133 / 330

4.8 Setting and Operation of Sweep
WF1967/WF1968 4-83
• Marker frequency [Marker] (second page of the setting screen)

P.4-79
• Stop level [StpLvl] (second page of the setting screen)

P.4-76
The setting used for gated single sweep only.
• Oscillation stop unit of the gated single sweep [OscStop] (second page of the setting screen)

P.4-76
The setting used for gated single sweep only.
• Synchronization/sub output selection [SubOut] (third page of the setting screen)

P.4-79
4.8.5 Setting Phase Sweep
For the sweep setting screen and the common operation method, please refer to P.4-71, P.4-74
a) Phase sweep example
Examples of a continuous sweep and linear shuttle.
Shuttle sweep
When the phase increases, the frequency rises as by the following value. When the phase decreases,
the frequency falls by following value.
b) To select phase sweep
c) Waveform or mode where phase sweep is unavailable
Noise and DC cannot perform phase sweep.
FSK, PSK and PM modulation are canceled (modulation function turned off) when phase sweep is
selected.
d) Items necessary for phase sweep
Set the following items on the second page of the setting screen. The phase setting on first page of
the setting screen becomes invalid, and the current phase is displayed.
• Starting phase [Start]
• Stop phase [Stop]
• Sweep time [Time]
Time to change from the starting phase to the stop phase.

P.4-74
• Sweep Mode [SwpMode]
(deg)
(sec) time Sweep
1
360
phase Start - (deg) phase Stop
×
Select [Phase] in the sweep type setting menu
When the oscillation mode [Mode] is set to
sweep oscillation mode [SWEEP], select the
sweep type [SwpType] on the second page of
the setting screen to display the selection list.
Selecting phase [Phase] sets the phase
sweep.
Sweep value
Start value
Sweep time
Sweep time
Stop value
Output signal