NF FRA5022, Instruction Manual

Page: 50 / 145

3.5 Basic Operations
FRA5022
3-20
3.5.5 Sweep Menu Screen
The Sweep Menu Screen allows you to set the items for sweep measurement.
Figure 3-10 Sweep menu screen
■
Setting memory selection SETTING memory
Value range: 0 - 9
Description:
FRA5022
can use 10 individual settings memories.
The settings in the sweep screen are not limited to changing the
settings of the actual measurements but can also be registered in the
specified setting memories.
Initial values: 0
■
Setting memory title TITLE
Value range: Maximum 18 characters using the following:
・
Alphabet (upper case A to Z)
・
Numerical characters (0 - 9) and decimal point
・
Other characters _ (white space),
-
, +, (, ), /
(the underscore above denotes white space.)
Description: Title for each setting memory.
With each press of the numeric key, the number is switched to
alphabets and symbols.
Pressing the right cursor key
▽
moves the input position to the right.
Initial values: Empty string
Displays the
options available
for the selected
item.
Setting value
Setup items:
select with the
Up/Down cursor
keys
.
Scrollbar:
Indicates the
approximate position
of the current item in
the window when the
entire menu cannot
be fully displayed.
Three sub-menus: select with the Left/Right cursor keys
△ ▽
.
SWEEP freq
.
axis
= Log
0
） Log 1)Lin
MEAS mode
MEAS integ
.
time
MEAS integ
.
cycle
MEAS delay time
SWEEP freq
.
axis
SWEEP freq
.
max
SWEEP freq
.
min
SWEEP points
100
10.000Hz
100.00kHz
Log
0.00s
1
0.10s
CH2/CH1
M E N U < S Y S T E M > < S W E E P > < S P O T >
▲
▼