NexusLink WB-1750-KIT, User Manual, Page: 16 / 58

15
Chapter 3 Web User Interface
This section describes how to access the device via the web user interface (WUI)
using an Internet browser such as Internet Explorer (version 6.0 and later).
3.1 Default Settings
The factory default settings of this device are summarized below.
• LAN IP address AP: 10.0.0.2
• LAN IP address STA: 10.0.0.10
• LAN subnet mask: 255.255.255.0
• Administrative access (username: root , password: 12345 )
Caution : The LAN setting default is DHCP mode, if a device connects to the DHCP
network, the LAN IP will be changed by the DHCP server assigned.
Technical Note
During power on, the device initializes all settings to default values. It will then
read the configuration profile from the permanent storage section of flash memory.
The default attributes are overwritten when identical attributes with different
values are configured. The configuration profile in permanent storage can be
created via the web user interface or telnet user interface, or other management
protocols. The factory default configuration can be restored either by pushing the
reset button for more than ten seconds until the power indicates LED blinking or
by clicking the Restore Default Configuration option in the Restore Settings screen.