Toll Free: (866) 501-1683 / Phone: (905) 458-5455 / Fax: (905) 458-5484
Page 26 of 38
3.
Remove the yellow thread plug in the outermost bolt hole.
4.
Rotate the blade around the outer retaining bolt and tighten the inner retaining bolt
into the new hole (see Figure 17).
FIGURE 1
FIGURE 1
FIGURE 1
FIGURE 17
7
7
7:
:
:
: ROTATE THE BLADE
5.
Replace the yellow thread plug in the old hole and re-tighten the outer retaining
bolt.
4.3
4.3
4.3
4.3
FLOAT BLADES
FLOAT BLADES
FLOAT BLADES
FLOAT BLADES
Clip-on float blades are an optional addition to your NXT-90, allowing you to begin the
trowelling operation much sooner after the concrete pour than the standard finishing
blades. The increased surface area of the float blades allows your NXT-90 to “float” on
wetter concrete than the finishing blades will permit.
FIGURE 1
FIGURE 1
FIGURE 1
FIGURE 18
8
8
8:::: TYPICAL CLIP-ON FLOAT BLADE
