MASTER
TRACE
A.13
Appendix A Display Message
Details - Setpoints
This message asks you to disable Address Mode and check that the Control
Module Address LED is off. Press [MSSG
ò
] to continue. Refer to Chapter 5.1.2.
MESSAGE NO:
S3-21b
APPLIES TO:
Address Enabled Control
Module
DEFAULT VALUE: None
VALUE RANGE:
None
DISPLAY MODE:
Advanced
RESTRICTIONS: MR100 Interface Module
If you receive the message “NO RESPONSE …”, check that the Control Module
Address is “enabled” or refer to Appendix C: Summary of Alarms and their Causes,
NO RESPONSE ALARM. Press [MSSG
ò
] to proceed.
PRESS MSSG DOWN
TO CONTINUE
NO RESPONSE
ADDRESS LED OFF?
CONT - MSSG DOWN
ABORT - RESET
SET ADDR ENABLE
ADDRESS LED ON
ENTER MODULE #:
1
?
[STORE]
ô
ô
yes [STORE]
ARE YOU SURE?
no
?
SET MODULE
NUMBER? no
?
yes [STORE]
NO RESPONSE
ADDRESS LED OFF?
PRESS MSSG DOWN
TO CONTINUE
ô
MESSAGE NO:
S3-22
APPLIES TO:
Address Enabled Control
Module
DEFAULT VALUE: no
VALUE RANGE: yes, no
DISPLAY MODE: Advanced
RESTRICTIONS: MR100 Interface Module
This function changes the Module Number of a connected Control Module which
has been placed in Address Enabled mode. Select “yes” to proceed. Select “yes”
again to confirm.
Enter the new Module Number. The Module Number of each Control Module on a
data highway or connected to a MR100 Interface Module must be unique. Select
the Module Number by pressing [VALUE
ñ
] or [VALUE
ò
] and then [STORE].
This message asks you to confirm that the Control Module Address is “enabled”.
The Control Module Address light must be on. Press [MSSG
ò
] to proceed. Refer
to Chapter 5.1.2.
MESSAGE NO:
S3-22a
APPLIES TO:
Address Enabled Control
Module
DEFAULT VALUE: None
VALUE RANGE: None
DISPLAY MODE: Advanced
RESTRICTIONS: MR100 Interface Module
If you receive the message “NO RESPONSE …”, check that the Control Module
Address is “enabled” or refer to Appendix C: Summary of Alarms and their
Causes, NO RESPONSE ALARM. Press [MSSG
ò
] to proceed.
SET ADDR DISABLE
ADDRESS LED OFF
PRESS MSSG DOWN
TO CONTINUE
ô
Summary of Contents for MASTERTRACE
