G2-HYDROMET Quick Start
For best results, setup your new product in the office/lab. Collect a few
data points and become familiar with the system prior to field deployment.
1
Go to
V2.WQDataLIVE.com/Getting-Started
2
Create a new account or sign into an existing
account and enter the Claim Code found on
the serial label to access the device’s data
3
Place the HYDROMET in an area with strong
cellular coverage and connect the antenna
4
Connect the Solar Pack’s UW-6 to the
HYDROMET’s UW-6 pigtail to power the device
(device will beep once when powered)
5
Refresh WQData LIVE and confirm the Diagnostic
Data Last Contact timestamp has been updated
(May take up to 1 minute*)
6
Deploy the device by screwing it onto a
leveled 2” NPT pole and orienting it
north using the Airmar alignment mark
7
Angle the solar panel by removing the
outter angle adjustment bolt with the
included 3/16” hex wrench, tilting to the
desired angle (30° or 45°), and replacing the bolt
Connect Optional Hydrological Sensor
8
Connect the Hydrological sensor to the UW-8 pigtail
9
On WQData, click the G2-HYDROMET’s icon in the
righthand Site List panel to access the Remote Device
Configuration dialog and queue a Detect Sensors and Sensor
Read command (check the boxes and click SAVE)
10
Cycle power (UW-6 pigtail) to
execute the remote command
11
Confirm the new parameters
are online (May take up to 3
minutes for detection and
upload)
Serial Label
