Configure Fibre
If your system is configured for Fibre Channel, clicking
Configure Host Access
takes you to the
Configure
Fibre
page, which allows you to change settings for each Fibre Channel host port on each RAID Controller.
Figure 3-115:
Configure Fibre
page (two ports per controller)
Some Nexsan units have four Fibre Channel ports per controller. For those units, the
Configure Fibre
page
looks like this:
Figure 3-116:
Configure Fibre
page (four ports per controller)
The information is arranged by Controller and then by host port. The
Current Status
row shows the link status,
speed, and topology.
►
To change Fibre Channel host configuration:
1. For each Fibre Channel host port, configure the following settings:
Topology
: Select
Loop
,
Point-to-point
, or
AUTO
(the default) from the drop-down list.
Loop ID
: Select an ID number from
0
to
126
, or
AUTO
(the default), from the drop-down list.
Chapter 3: The Graphical User Interface — Configure Host Access
Nexsan High-Density Storage
User Guide
163