DESCRIPTION
ePS6
Page
5
/
18
DESCRIPTION
→
The ePS6 is a compact full-range 2 ways speaker.
→
Asymmetrical HF dispersion
“ S” type.
→
ePS6 can be used alone or with eLS400 subwoofers
→
The speaker is equipped with 2 pairs (In/Out) of screw terminal blocks, permissible cables from 0.75 mm
2
to 3.31 mm
2
(12 to 15 AWG) copper section. Cable with maximum outside diameter of 11mm.
→
To wire ePS6, slit the membrane of the grommet crosswise, pass the cable through and make the connection to the screw
terminals. Place the IPCOV.
→
IP55: be careful to place the IPCOV correctly.
→
Amplification
•
The ePS6 speakers must be used with a NEXO processor to handle EQ, phase alignment, crossover and
excursion/thermal protection for the system loudspeaker.
•
The following table shows the number of ePS6 speakers and eLS400 subwoofers usable with each solution.
DTD + DTDAMP4X0.7
DTD + DTDAMP4X1.3
NXAMP4X1mk2
NXAMP4X2mk2
NXAMP4X4mk2
ePS6
Up to 2 per channel
Up to 2 per channel
Up to 4 per channel *
Up to 4 per channel
Up to 4 per channel
eLS400
1 per channel
1 per channel
Up to 2 per channel *
Up to 3 per channel
Up to 3 per channel
* Recommended powering solution
