Copyright © 2014 NEXCOM International Co., Ltd. All rights reserved
12
VMC 1100 User Manual
Chapter 2: Using the GPS Feature
C
haPter
2: u
sIng
the
gPs f
eature
The VMC has a built-in GNSS receiver module by default.
You need to install the third-party GPS navigation software to take advantage
of the GPS feature.
Setup and Using GPS Information
Users can use the GPSinfo.exe program to verify that the GPS is correctly
configured and working properly. Also, users can use the GPSinfo.exe pro-
gram to enable WAAS/EGNOS and power saving mode.
1. Go to Device Manager to ensure the device is installed correctly.
Module: VIOB-GPS-02T
Chip:
•
Receiver Type:
•
O-M8N 72-channel u-blox M8 engine
•
GPS/QZSS L1 C/A, GLONASS L10F, BeiDou B1
•
SBAS L1 C/A: WAAS, EGNOS, MSAS
•
Navigation Update Rate:
•
Up to 18 Hz
•
Accuracy Position:
•
2 m CEP
•
Acquisition
:
•
Cold starts: 26s
•
Aided starts: 2s
•
Hot starts: 1s
•
Sensitivity:
•
Tracking: –167 dBm
•
Cold starts: –148 dBm
•
Hot starts: –156 dBm
COM Port for GPS: This COM comes from USB, so the address will change
by the order of installing driver.
Baud Rate: 9600
