Nexcelom Bioscience Cellometer Auto T4, User Manual, Page: 8 / 75

Chapter 1. Introduction
8001009 Cellometer® Auto T4 User Manual Rev C 2
CONTENTS OF SHIPPING CONTAINER
Cellometer Auto T4 Instrument
Power Cord
(Figure 1)
USB Connector Cable (Figure 2)
USB Drive
Contains Cellometer Auto T4 Software; used to
install software on an Operating Computer not
provided by Nexcelom
Note: Store USB drive where it can easily be located
if software needs to be installed on another computer.
Cellometer Auto T4 User Manual and Quick Start Guide
Available as .pdf files on the USB Drive with software
Focus Guide
Graphic sheet intended to help users adjust instrument focus
Cell Counting Chambered Slides (Figure 3)
One box of 75 disposable slides; each slide contains
two separate counting chambers
Nexcelom-provided Laptop
(Figure 4)
If a laptop was purchased from Nexcelom (optional) along
with the instrument, it will be shipped in a separate box. This
laptop will have the specifications listed below:
• Windows 10 OS 64 bit
• Intel Core Processor i3-8130U (2.20GHz)
• 4GB RAM
•
500GB7200RPM SATA NoteBook Drive
• 15.6” 1366 x768 HD LED Wide Screen
If a laptop was not purchased from Nexcelom, the following minimum specifications are required for an
Operating Computer:
•
Windows 7, 8, or 10 PC
• 1.6 GHz or higher processor
• 2GB RAM (4GB RAM or higher recommended)
• USB 2.0 or higher
• Display resolution: 1024 x 768 pixels or higher
Note
: An Intel Mac with Parallels/Windows may be substituted for a Windows computer, but this setup is
not recommended.
Figure 2. USB Connector Cable Figure 1. Power Cord
Figure 4. Nexcelom Laptop
Figure 3. Chambered Slide