NewTek TriCaster TCXD300, User Manual

Page: 142 / 290

Page | 126
Connection Type menu offerings vary depending on the Video Standard for the session.
TriCaster International provides PAL and NTSC-J session options, in addition to NTSC . The
Connection Type menu options for a PAL session list PAL HD and SD format options.
Choosing NTSC as the session Video Standard results in a Connection Type list with appropriate
formats, and it is similar for NTSC-J . Changing from one Video Standard to another requires
opening a new session.
Hint: All connected cameras must conform to the current Video Standard for the session.
TERMINATION
The Termination switch toggles a 75 ohm resistance which may be required for certain video
sources. In a situation where you intend to loop a house sync signal through the TriCaster to
other devices, Termination should be turned off.
8.2.2 PROC AMP
Figure 114
The lower portion of the Input Settings tab contains Proc Amp settings. These settings are
identical to those discussed previously in Section 8.1.2. Of course, these settings are applied to
the individual video
inputs , thus before output Proc amp settings (which affect all sources
equally).
When the Proc Amp is enabled for a specific source, a small yellow flag is displayed in the upper-
right corner, just above the corresponding monitor in any of the three main monitor tabs.