Newport XPS-D, Startup Manual

Page: 33 / 58

XPS-D Controller Start-Up Manual
•
Once you are logged in, you can change the IP configuration by following the steps
described in section 3.5.5 or 3.5.6 depending on your configuration.
NOTE
If you want to reset the IP address to the default factory setting, follow the section
3.5.5: “Connecting the XPS to a Corporate Network using Static IP
Configuration” to set the IP address back to 192.168.0.254.
3.5.7 Testing your XPS-PC Connection and Communication
To check if the XPS communicates with to the host computer, send a ping message
from the computer to the XPS. This is done through the Windows menu: Start->Run->,
then type: ping + IP address of the XPS. See the example below for the IP address
192.168.254.254:
If the XPS is connected and communicates properly, it replies in the terminal window
that appears after clicking on the OK button:
If the XPS controller is not communicating, the window displays that the time delay of
the request is exceeded. Ensure that the correct cable and IP addresses are set properly.
25 EDH0395En1031 – 09/18