Newland NLS-HR1050-7 Series, User Manual

Page: 155 / 185

** Enter Setup
145 Exit Setup
Set Length Range for Code 11
The scanner can be configured to only decode Code 11 barcodes with lengths that fall between (inclusive)
the minimum and maximum lengths.
The supported maximum length is 255 characters. If minimum length is set to be greater than maximum
length, the scanner only decodes Code 11 barcodes with either the minimum or maximum length. If
minimum length is same as maximum length, only Code 11 barcodes with that length are to be decoded.
Set the Minimum Length Set the Maximum Length
Example: Set the scanner to decode Code 11 barcodes containing between 8 and 12 characters.
1. Scan the Enter Setup barcode.
2. Scan the Set the Minimum Length barcode.
3. Scan the numeric
barcode “8”. (See the
Digit Barcodes section in Appendix)
4. Scan the Save barcode. (See the Save/Cancel Barcodes section in Appendix)
5. Scan the Set the Maximum Length barcode.
6. Scan the numeric
barcode “1”.
7. Scan the numeric
barcode “2”.
8. Scan the Save barcode.
9. Scan the Exit Setup barcode.