Newland NLS-FM515 Series, User Manual

Page: 150 / 162

140
Factory Defaults Table (MONGO-M_V2.ST.G02.2)
Parameter Factory Default Remark
System Settings
Barcode Programming Disabled (Exit Setup)
Programming Barcode Data Do not transmit
Scan Mode Level Mode
Decode Session Timeout 0ms 1-3,600,000ms; 0: Infinite
Reread Timeout Enabled, 0ms 1-3,600,000ms
Reread Timeout Reset Off
Good Read Delay Disabled, 500ms 1-3,600,000ms
Read Barcode On/Off On
Bad Read Message
On
“?” 1-7 characters
Trigger Commands Disabled
Start Scanning Command <SOH> T <EOT>
Stop Scanning Command <SOH> P <EOT>
Illumination Normal
Good Read LED On
Good Read LED Duration 20ms
Security Level 1
Enable/Disable Switching Input
Disabled
Trigger Slope
Negative Slope
Trigger Duration
0ms 0-60,000ms
Debounce Duration
10ms 0-250ms
Enable/Disable Switching Output
Disabled
Output High/Low Level Output High Level
Output Duration
400ms 0-60,000ms
Enable Level Output
Output Level After a Good Read
Stop Level Output
Stop Level Output When Another Decode
Session Starts
Default Interface RS-232
RS-232 Interface
Baud Rate 9600
Parity Check None