Newland NLS-EM20-EX, User Manual

Page: 23 / 187

Startup settings
Image stabilization timeout (sensing mode)
In the sensing mode, when the scanner stops reading the code, it will enter a process of re-adapting to the changes in the reading environment (image), and it will enter the sensing state after the image stabilization times out
Wait for the barcode to appear. By modifying the image stabilization timeout, the time to adapt to the environment can be adjusted. The setting range is 1 To 3000 Milliseconds, default is 200 millisecond.
[Image stabilization timeout (sensing mode)]
Delay setting
Reread delay
•
Turn on: If the scanner reads a bar code and reads the bar code for the second consecutive time within the reread delay time, the bar code read for the second time will be ignored and will not
Output.
•
shut down: The reread delay is invalid. The scanner can continuously read the same barcode at any time.
Default: Reread delay is off.
* *
【Open】
* * 【shut down】
13
Exit settings