Newland HR42 Halibut, User Manual

Page: 42 / 222

Enter Setup
** Exit Setup 28
Continuous Mode
Continuous Mode: Pressing the trigger activates a decode session. The decode process continues until the barcode is
decoded. After finishing a decode session, the scanner waits for the timeout between decodes to expire and then
automatically starts next session until you press the trigger a second time.
Continuous Mode
Timeout between Decodes sets the time period between the end of one decode session and the start of next session. It is
programmable in 1ms increments from 1ms to 10,000ms. The default timeout is 500ms.
Timeout between Decodes
Set the timeout between decodes to 800ms:
1. Scan the Enter Setup barcode.
2. Scan the Timeout between Decodes barcode.
3. Scan the numeric barcodes “8”, “0” and “0” from the “Digit Barcodes” section in Appendix.
4. Scan the Save barcode from the “Save/Cancel Barcodes” section in Appendix.
5. Scan the Exit Setup barcode.