** Enter Setup
Exit Setup
34
Bad Read Message
Scan the appropriate barcode below to select whether or not to send a bad read message
(user-programmable) when a good read does not occur before trigger release, or the decode session
timeout expires, or the scanner receives the command string of “
7E 01 30 30 30 30 40 53 43 4E 43 54 4D
30 3B 03
” (~<SOH>0000@SCNCTM0;<ETX>). This feasure is
NOT
available in the Continuous mode.
** Bad Read Message OFF
Bad Read Message ON
A bad read message can contain two characters. To set a bad read message, scan the
Set Bad Read
Message
barcode, the numeric barcodes and the
Save
barcode. The default setting is none.
Set Bad Read Message
Example: Set the bad read message to “F”
1. Scan the
Enter Setup
barcode.
2. Scan the
Set Bad Read Message
barcode.
3. Scan the numeric barcodes “4” and “6” from the “Digit Barcodes” section in Appendix.
4. Scan the
Save
barcode from the “Save/Cancel Barcodes” section in Appendix.
5. Scan the
Exit Setup
barcode.
Summary of Contents for HR11+ Aringa
