Newland BS8060 Piranha, User Manual

Page: 18 / 232

4
Button Functions
Scan/Power Button
*
Press the button to scan barcode.
* Hold down the button for 3 seconds to power the scanner on.
Delete/Reset Button
* Press the button to remove the corresponding data from the flash memory in one of the following
conditions before scanning the barcode to be deleted: (i) Bluetooth mode enabled but no Bluetooth
connection established; (ii) Bluetooth mode & Batch Transmission enabled; (iii) USB mode enabled
but no USB cable connection made; or (iv) USB mode & Batch Transmission enabled.
*
Hold down the button for 7 seconds to reset it.
Function Button
*
Press the button to turn on or off the HID keyboard of the connected iOS device in the Bluetooth
mode.
*
Hold down the button for 3s to start data transmission in either of the following conditions: (i)
Bluetooth mode & Batch Transmission enabled; or (ii) USB mode enabled and the scanner
connected to PC via USB cable.
Scan/Power Function Button
* Hold down the two buttons at the same time for 3 seconds to toggle between the Bluetooth mode and
USB mode.
Delete/Reset Function Button
*
Press the two buttons at the same time to unpair the paired Bluetooth device from the scanner in
Bluetooth mode and to make the scanner discoverable by other Bluetooth device.
*
Hold down the two buttons at the same time for 7s (then the red and blue Function LEDs flash
alternately to indicate the scanner enters the update status) to update the firmware after clicking the
“Start” button of the firmware upgrade utility on PC that the scanner is connected to using the USB
cable.
Note: If the update fails or you accidentally enter the update status, you need to hold down the Delete/Reset button for
7s to reset the scanner.
Scan/Power Delete/Reset Button
*
Press the two buttons at the same time to check the battery level with the Charging/Battery LED.
* Hold down the two buttons at the same time for 3s to delete all stored data in the flash memory in
either of the conditions: (i) Bluetooth mode enabled, Bluetooth connection established, and Batch
Transmission & Require Data Transmission Confirmation enabled; or (ii) USB mode enabled, the
scanner connected to PC via USB cable and Require Data Transmission Confirmation enabled.