6
http://www.NewAir.com
ASSEMBLY & INSTALLATION
Before connecting the appliance to a power source, let it stand
upright for approximately 2 hours.
This will reduce the possibility
of a malfunction in the cooling system from handling during
transportation.
This beverage cooler is a freestanding unit and should not be built in to
surrounding cabinetry. Allow for proper air clearance around the cooler. The
recommended clearances are as follows:
Sides: ¾” (19 mm)
Top: 4” (100 mm)
Back: 2” (50 mm)
Before operating your beverage cooler for the first time, follow these steps:
1.
Clean the interior surface of the unit with lukewarm water and a soft
cloth.
2.
Place the cooler on a level surface that will be strong enough to
support the unit when it is fully loaded. To level your cooler, adjust the
front feet located at the bottom of the unit.
3.
Install the cooler away from direct sunlight and heat sources such as
stoves, heaters, or radiators. Direct sunlight may affect the unit’s
acrylic coating, and nearby heat sources can increase electrical
consumption. Extreme cold or hot ambient temperatures may also
prevent proper performance.
4.
Once the cooler is plugged in, let the beverage cooler run for at least
30 minutes. Do not change the temperature or adjust any settings at
this time.
REVERSING THE DOOR SWING
1.
To reverse the door swing of the unit, remove the plastic hinge cover at
top of the unit.
2.
Unscrew the door hinge.
3.
Flip door upside-down.
4.
Attach door to opposite side of unit with screws.
5.
Replace plastic door hinge cover.
