EN
www.newair.com
11
The battery gear should be set from H to M or from M to L if there is a voltage
protection code F1 shown on the panel. The battery gear should be set to H if
the product keeps working after turning off the car engine, or the product may
drain the battery.
VOLTAGE REFERENCE
Input
Mode
DC 12V
DC 24V
CUT IN
CUT OUT
CUT IN
CUT OUT
L
9.0V
10.9V
21.3V
22.7V
M
10.1V
11.4V
22.3V
23.7V
H
11.1V
12.4V
24.3V
25.7V
*Reference numbers may change depending on the scenario and external
factors.
*USB output: +5V DC/1A, suitable for small devices like mobile phones, tablets,
etc.
Reset:
switch off the fridge, keep pressing
until E1 displays, then press
“
+
”
and “
-
”
at the same time until displays as below:
Instructions for solar charging:
When using solar panel to charge the
refrigerator, place the refrigerator in a cool place to avoid overheating that
would cause malfunction of the refrigerator. The battery icon on the display
will show the charging status when it is charging.
The charging input power should be higher than the working power of the
refrigerator (about 40-45W), or press the power button to make the
refrigerator enter the standby state, otherwise the battery will not be able to
charge. It is recommended to use a 100W solar panel.
