New lift FST, Manual

Page: 47 / 174

4 Technical Data
4.2 FST-Controller
FST_HB.EN04/03
45
Terminals and plugs
FST: X1 Pre-selection circuit board
1 Motor monitoring (input)
2 Standstill monitoring (input)
3 Brake monitoring (input)
4 Auxiliary and ramp control “ON” (input)
5 Auxiliary and ramp control “UP” (input)
6 Auxiliary and ramp control “DOWN” (input)
7 Correction switch, bottom “CB” (input)
8 Correction switch, top “CT” (input)
9 Zone enabling (output)
10 Zone signal (input)
11 Simulated encoder-B (input)
12 Override safety monitoring device A6 (output)
13 Pre-selection relay 0 (output)
14 Pre-selection relay 1 (output)
15 Pre-selection relay 2 (output)
16 Pre-selection relay 3 (output)
17 Pre-selection relay 4 (output)
18 Pre-selection relay 5 (output)
19 Pre-selection relay 6 (output)
20 Pre-selection relay 7 (output)
21 Pre-selection relay 8 (output)
22 Pre-selection relay 9 (output)
23 Pre-selection relay 10 (output)
24 Pre-selection relay 11 (output)
25 Pre-selection relay 12 (output)
26 Opto-coupler “Emergency stop” (input)
27 Opto-coupler “Door C” (input)
28 Opto-coupler “Door B” (input)
29 Opto-coupler “Door A” (input)
30 Opto-coupler “Door lock” (input)
31 +24V (permanent)
32 +24V (permanent)
33 +24V (pre-selection supply)
34 +24V (pre-selection supply)
35 + 12 ... +24V (emergency power supply unit)
36 0V / GND
37 0V / GND
38 0V / GND
39 0V / GND
40 0V / GND