New lift FST-2, Manual, Page: 44 / 194

4 Technical data
4.2 FST-2-Controller
42
FST-2_HB.EN12/05
Jumper J131 .. J136 Specification of shaft positioning type
Jumpers J131, J133, J135 and J136 specify the type of shaft positioning
used (rotation encoder (absolute value or incremental) or USP).
Encoder signals over FST X12 (USP, LIK type 13, LIK type 10, INK type
15):
Encoder signals over trailing ribbon cable FSM X25 (LIK type 13a, LIK
type 10a, INK type 15a):
LEDs The LEDs listed in the following table are located next to the operating
panel of the FST-2-Controller.
LEDs The LEDs listed in the following table are located on the FST-2-Controller
next to terminals X2 .. X4.
J131 J133 J135 J136
2-3 2-3 2-3 2-3
J131 J133 J135 J136
1-2 1-2 1-2 1-2
LED Colou
r
State Description
RUN green on The FST-2-Controller is switched on
and working correctly.
off The FST-2-Controller has no power
supply.
STATUS green on The drive processor is working correctly.
flashing Landing control is switched off.
off Fault in the drive processor.
ERROR red on Drive not possible.
flashing One or more errors were added to the
error list.
off There is no error or event.
LED Colou
r
State Description
IN green flashing Incoming data packets on LON bus
OUT green flashing Outgoing data packets on LON bus
LD8 green on Power supply group bus