New lift FST-2, Manual, Page: 20 / 194

3 FST-2-Controller user interface
3.1 LC-Display and messages
18
FST-2_HB.EN12/05
Each number codes four functions (bits) of the F1/F2 table with its decimal
value. The decimal value of the number corresponds to the sum of the
values of the activated functions according to the following tables.
* Signal only relevant for door versions A and B.
Example:
State byte F1 = 6c and state byte F2 = 21
This results in the following hexadecimal numbers:
F1:
Number 1 = “c” (decimal = 12)
Number 2 = “6” (decimal = 6)
F2:
Number 1 = “1” (decimal = 1)
Number 2 = “2” (decimal = 2)
The decimal numbers are calculated from the following values:
F1:
Number 1 = 12 = 8 + 4
Bit Number Value Setting
F1 =
Byte F1
0
Number 1
(right number)
1 active FSM car control module configured
1 2 active Door locked
2 4 active Door reversing
3 8 Door completely
open
Limit switch “door open”
4
Number 2
(left number)
1 Door completely
closed
Limit switch “door closed”
5 2 active Photocell interrupted
6 4 active Reversing contact
7 8 active Minimum load input*
Bit Number Value Setting
F2 =
Byte F2
0
Number 1
(right number)
1 on Car light sensor*
1 2 active Inspection signal “fast”
2 4 active Inspection signal “down”
3 8 active Inspection signal “up”
4
Number 2
(left number)
1 active Inspection signal “ON”
5 2 active Door closing motor
6 4 active Door opening motor
7 8 active Door ready for drive
SAFETY CCT CLOSED
Door-A: F1=6c F2=21
00 13:06: