New lift FST-2, Manual, Page: 150 / 194

6 Programmable inputs and outputs
148
FST-2_HB.EN12/05
User defined
error messages
The FST-2-Controller enables the output of arbitrary error and event
messages This means that any error message provided by the FST
software can be assigned a programmable input/output. This enables
forwarding of user defined error states to the outside world.
Programming
Programming of the inputs and outputs is done in the FST menu under
MAIN MENU - Configuration - I\O Configuration.
The
following submenus are available:
Setting the RAW register
The RAW register is an eight digit hexadecimal value coding a 32-bit
register. With the RAW register, a function from the function table
(page 151) can be assigned to the respective terminal. Furthermore, active
state, signal direction and function parameters are set in the RAW register.
Select menu item
MAIN MENU - Configuration - I\O
Configuration - I\O Ports - RAW
and select the input/output to
be parametrised (
S
+
£
).
Submenu Description
I\O ports
The programmed function is assigned to the input/
output with the
RAW
register. Ports
Port [0]
..
Port [79]
are programmable
I\O flags
Programming of up to 8 flags that represent an “OR”
link of different controller functions.
I\O error
Select up to three error messages from the error list.
The selected error messages are stored as
USER
ERROR [0]
..
USER ERROR [2]
.