New Leader Raven OMNiPOWER NL5000 G5, Operator'S Manual

Page: 40 / 268

- 38 -
www.NewLeader.com
(800) 363-1771
317314-C
Raven OMNiPOWER NL5000 G5
Insert Installation
Parts Needed:
Description Qty
Divider - Lower Weldment 1
Bolt - Carriage 3/8-16NC x 1 SS 4
Washer - Flat 3/8 SS 8
Nut - Lock 3/8-16NC SS 4
Cover - Weldment Rear 1
Pin - Hair 2
1� Remove hardware from rear two chain shield holes
on each side of M
ulT
A
pplier
and set aside�
2� Figure 1 - Install M
ulT
A
pplier
Hillside Divider
Support (A) and fasten to M
ulT
A
pplier
by reinstalling
chain shield hardware� Slip M
ulT
A
pplier
Hillside
Divider (B) up into place and loosely install supplied
hardware�
B
A
B
A
Figure 1 - M
ulT
A
pplier
Hillside Divider
3� Verify that Divider is square by measuring from
each side of the Divider to the M
ulT
A
pplier
chain
shields� Measurements must be equal�
4� Tighten all hardware to recommended torque�
5� Figure 2 - Install Conveyor Cover (C) and secure
with hair pins D) on each side�
C
D
C
D
Figure 2 - Conveyor Cover
Hillside Divider & Conveyor Cover - MultApplier
The following steps apply to M
ulT
A
pplier
units only� Continue to “Lower Divider - M
ulTi
B
in
” for M
ulTi
B
in
units�
New Leader Manufacturing will not be liable for misapplied material due to an improperly
adjusted divider, spreader or both�