7 - MAINTENANCE
Power Take-Off (PTO) clutch
The Power Take-Off (PTO) clutch engagement pres-
sure needs to be checked and adjusted to prevent slip-
page of the PTO during operation under load.
1. When the PTO clutch linkage is properly adjusted, the
PTO lever
(1)
should have
2 mm
(
0.079 in
) of free play
at the pin
(A)
when the PTO handle is in the "OFF"
position.
2. If the free play of lever is not correct, adjust the free play
by loosening jam nut
(2)
and shortening or lengthening
cable,
(3)
.
56061331N
1
3. Use a spring scale
(4)
to measure the force needed
to fully engage the PTO handle
(5)
. Proper amount of
force at end of handle to fully engage the PTO clutch is
125 - 142 N
(
28 - 32 lb
)
86090136N
2
NOTICE:
When PTO clutch linkage is properly adjusted, the total cable travel should be
21 mm
(
0.83 in
) while en-
gaging and disengaging the PTO clutch.
7-27
Summary of Contents for Workmaster 50
