New Holland WORKMASTER 35, Operator'S Manual

Page: 79 / 180

4 - OPERATING INSTRUCTIONS
Cold starting aids
Your tractor has a diesel engine. Before starting a cold
engine, the precombustion chambers must be heated.
DANGER
Explosion hazard!
DO NOT use ether starting fluid. Explosion,
death, serious personal injury, or serious en-
gine damage could occur.
Failure to comply will result in death or serious
injury.
D0085A
NOTICE: When starting the machine after long periods,
avoid immediate use of hydraulics. It is necessary to al-
low time for enough lubrication of all moving parts before
subjecting the to work loads, particularly if outdoor tem-
peratures approach
0 °C ( 32 °F ). Run the engine at 1300
to 1500 RPM for approximately fifteen minutes to bring
the transmission oil up to normal operating temperature.
Failure to comply could result in damage to the machine.
To preheat the engine, turn the key switch counterclock-
wise to the "HEAT" position
(1) or clockwise to the “ON”
position (2) . The cold start indicator light (3) will illuminate
for approximately ten seconds. The glow plugs heat the
precombustion chambers during this time. After the light
goes out the tractor can be started. When the key is re-
leased from the “HEAT” position the key switch will return
to the “OFF” position.
NOTE: The preheat is auto-timed, when the indicator light
goes off, the power to the glow plugs is also removed.
NOTE: A coolant immersion heater is available as a
dealer installed option. This heater allows for easier
starting in temperatures below -18 °C ( 0 °F ) by warming
the engine coolant.
NHIL12CT00692AA
1
NHIL14CT00501AA
2
4-11