New Holland WORKMASTER 35, Operator'S Manual

Page: 53 / 180

3 - CONTROLS AND INSTRUMENTS
Cruise control
WARNING
Loss of control hazard!
To maintain optimum control of the machine,
do not use the cruise control at high speeds
or when roading.
Failure to comply could result in death or se-
rious injury.
W0978A
The HST cruise control lever (1) is located on the right
-hand side of the operator’s platform. It is used to maintain
a constant forward speed.
NOTE: The cruise control is only found on HST model
tractors.
When the desired travel speed is reached, push down-
wards on the cruise control engagement lever while de-
pressing the HST forward pedal
(2) . The engagement
lever will mechanically retain the forward pedal in the de-
sired speed location. To disengage the cruise control,
depress the HST forward pedal slightly or depress both
brake pedals
(3) .
NHIL12CT00693AA
1
NHIL12CT00691AA
2
Transmission shuttle shift lever
NOTICE: Do not attempt to operate the shuttle lever while
the tractor is moving, it may cause damage to the syn-
chromesh gear. The clutch pedal must be depressed and
tractor motion stopped to operate the shuttle lever.
NOTE: The shuttle shift lever is only found on gear model
tractors.
The transmission shuttle shift lever (1) is located on the
left-hand side of the dash panel. The shuttle shift lever is
used to engage the transmission into forward or reverse
mode while depressing the clutch pedal. Move the lever
forward for forward travel and rearward for reverse travel.
NOTE: The shuttle lever must be in the neutral (middle)
position to activate the safety start system, which allows
the engine to start.
93099335
1
3-7