New Holland WORKMASTER 35, Operator'S Manual

Page: 137 / 180

7 - MAINTENANCE
6. Slowly and momentarily remove plug (3) from the lower
side final drive housing. This will allow any air that
is trapped in the lower housing to escape, so that the
correct oil level can be achieved. Reinstall plug and tilt
axle the opposite direction. Repeat this procedure for
the other final drive housing.
7. Lower axle back to the ground.
8. Recheck oil level at dipstick, add oil if needed until oil
level is between the upper and lower marks of dipstick.
9. After correct oil level is achieved, tighten all plugs.
93110428
4
NOTE: Approximate fluid capacity for the front axle housing is 5.5 l ( 5.8 US qt ).
Transmission and hydraulic fluid
Changing the transmission, rear axle and hydraulic system oil
NOTE: Change the transmission, rear axle, and hydraulic
system oil after every 400 hours of operation.
NOTE: During cold weather operation, tractor hydraulic oil
can be changed to New Holland F200. The F200 oil is a
multi-viscosity oil which has improved flow characteristics
in low temperatures and can be used year round.
1. Place a suitable container beneath the transmission
and rear axle drain plugs (1) (without Mid PTO) and
(2) (With Mid PTO) to catch the used oil. With the oil
at normal operating temperature, drain the system by
removing the transmission and rear axle drain plugs.
Reinstall the plugs once the oil has drained. Discard
the used oil.
93100871
1
93100872
2
7-29