New Holland Workmaster 25S, Operator'S Manual, Page: 123 / 208

6 - WORKING OPERATIONS
Roll Over Protective Structure (ROPS) Fold up/down
DANGER
Roll-over hazard!
A folded Roll-Over Protective Structure (ROPS) does not provide roll-over protection. Do not operate
the machine with the ROPS folded as a standard operating mode. Raise the ROPS immediately after
low clearance use or transport.
Failure to comply will result in death or serious injury.
D0058A
DANGER
Crushing hazard!
Always wear the seat belt when operating the machine with the Roll Over Protective Structure (ROPS)
in the upright position. If the ROPS is in the folded position, the seat belt should not be used. Raise
the ROPS and wear the seat belt as soon as conditions allow.
Failure to comply will result in death or serious injury.
D0139A
WARNING
Machine damage can cause accidents!
While driving, make sure the Roll Over Protective Structure (ROPS) is correctly positioned to avoid
any damage. The ROPS and interconnecting components are a certified system. Any damage reduces
protection and weakens the structure.
Failure to comply could result in death or serious injury.
W0934A
WARNING
Avoid injury!
Always follow the procedure in this manual when you fold or unfold the Roll-Over Protective Structure
(ROPS).
Failure to comply could result in death or serious injury.
W1506A
CAUTION
Heavy parts!
The Roll Over Protective Structure (ROPS) is a heavy assembly. Use caution when you fold and stand
the upper ROPS frame.
Failure to comply could result in minor or moderate injury.
C0141A
Fold ROPS down
1. Loosen the M6 jam nut on the M6 anti-vibration bolts
(4) on the both sides of the ROPS.
2. Loosen the anti-vibration bolts on both sides.
3. Remove both the quick pins (3) from the locking pins
(2) .
4. Support the upper ROPS (1) , remove the locking
pins.
5. Roll the upper ROPS down toward rear of the tractor.
6. Install the locking pins to lock the upper ROPS in the
lowered position, hole
(A) .
7. Install the quick pins.
8. Tighten the anti-vibration M6 bolts.
9. Secure the anti-vibration bolts with the M6 jam nuts.
NHIL17CT00172AA
1
6-3