New Holland Workmaster 25 Tier 4B, Operator'S Manual, Page: 47 / 198

3 - CONTROLS AND INSTRUMENTS
3 - CONTROLS AND INSTRUMENTS ###_3_###
Operator's seat
Seat belt
The male end of the seat belt (1) is located on right -hand
side of the seat. To extend length of seat belt, pull out
on male end until correct length is obtained. To latch seat
belt, insert male end into the buckle
(2) located on left-
hand side of the seat. Make sure belt is securely buckled
and belt length is adjusted correctly for size of operator.
Use soap and water to clean the seat belt if necessary.
Do not use carbon tetrachloride, naphtha, etc., as these
substances will weaken the webbing. Additionally, do not
bleach or dye the webbing, as these products will also
weaken the webbing.
Replace the seat belt if it becomes damaged or worn.
NHIL12CT00690AA
1
3-1