New Holland T4.105, Service Manual

Page: 52 / 81

Engine - Engine and crankcase
Engine - Install
T4.105 with cab, with mechanical or power shuttle transmission [ZxJT0xxxx]
T4.105 less cab, with mechanical or power shuttle transmission [ZxJT0xxxx]
T4.115 with cab, with mechanical or power shuttle transmission [ZxJT0xxxx]
T4.115 less cab, with mechanical or power shuttle transmission [ZxJT0xxxx]
T4.75 with cab, with mechanical or power shuttle transmission [ZxJT0xxxx]
T4.75 less cab, with mechanical or power shuttle transmission [ZxJT0xxxx]
T4.85 with cab, with mechanical or power shuttle transmission [ZxJT0xxxx]
T4.85 less cab, with mechanical or power shuttle transmission [ZxJT0xxxx]
T4.95 with cab, with mechanical or power shuttle transmission [ZxJT0xxxx]
T4.95 less cab, with mechanical or power shuttle transmission [ZxJT0xxxx]
1. Refit the flexible belt on the alternator and take up the
slack according to the procedure in Alternator - Ten-
sion adjust (55.301) .
2. Reposition the compressor and the relevant belt follow-
ing this procedure:
- Put the compressor back on the support and with the
related pipe support. Secure with the bolts
– To mount the polyv belt, use the specific tool
380200011 .
(1) . Compressor clutch actuator drive bracket.
(2) . polyv belt pulley outer edge.
(3) . Tool recess. Used to drive the tool. This recess
houses the bracket (1) .
(4) . Tail. Used to drive the polyv belt in the pulley seat.
(5) . Hitching. Thanks to this recess, where the outer
edge (2) is housed, the tool remains hitched to the com-
pressor.
WLAPL4S10C101C
1
47803847 15/12/2014
10.1 [10.001] / 23