New Holland E26C, Operator'S Manual

Page: 200 / 282

6 - MAINTENANCE
Hydraulic oil suction filter
WARNING
Burn hazard!
Before performing any service on the hydraulic system, you must allow it to cool. Hydraulic fluid
temperature should not exceed 40 °C (104 °F).
Failure to comply could result in death or serious injury.
W0241A
WARNING
Pressurized system!
Never attempt to drain fluids or remove filters when the engine is running. Turn off the engine and
relieve all pressure from pressurized systems before servicing the machine.
Failure to comply could result in death or serious injury.
W0905A
Clean the hydraulic oil suction filter every 2000 h .
NOTICE: do not remove the hydraulic oil suction filter from the hydraulic tank before the hydraulic tank was empty.
1. Clean the top of the hydraulic tank, and clean the cover
of the inlet filter.
2. Remove the four bolts (1) , and the suction cover (2)
from the hydraulic oil tank.
3. Remove the oil suction filter (3) , and clean it with a
solvent.
4. Let it dry completely, and check for damage. If any
damage is found on its surface, replace it with a new
component.
5. Install a new O-ring (4) , and install the oil suction filter
on the suction cover (2) . Lock the suction cover (2) with
the four bolts (1) .
Tighten the bolts (1) to 55 – 83 N·m ( 40.6 – 61.2 lb ft ).
6. Check the hydraulic fluid level, and add if necessary.
SMIL16MEX0438AA
1
6-58