6 - MAINTENANCE
Track tension
WARNING
Tip-over hazard!
Only raise the track as little as necessary.
Failure to comply could result in death or serious injury.
W0276A
Check the track tension every
50 h
NOTICE:
if the tracks are too tight, they wear quickly. If tracks are not tight enough, they wear quickly and can catch
on the sprocket wheel or slide off the idler wheel or the sprocket wheel. Clean the tracks after work.
To check the tracks tension, proceed as follows:
1. Swing the upper structure perpendicular to the un-
dercarriage. Lower the attachment to the ground,
then lower the boom until the track is raised off the
ground. Place a block under the undercarriage and
raise the attachment off the ground.
2. Set the engine speed lever to the maximum speed
position.
3. Operate the travel control lever to move the raised
track forward and backward and shake off the mud.
4. Repeat the same operations for the other track.
SMIL16MEX0422AB
1
Checking the tension
1.
Stop the engine, then remove the key from the
starter switch.
2.
At the center of the track, measure the slack
(L)
between the bottom of the lower roller
(A)
and the
rubber track shoe
(B)
.
.
SMIL16MEX0423AB
2
3. The value of the slack must be within
10 – 15 mm
(
0.4 – 0.6 in
).
4. Adjust the tension as necessary, then lower the
track to the ground.
5. Repeat the same operations for the other track.
6-28
Summary of Contents for E26C
