New Holland 200 Series, Operator'S Manual

Page: 210 / 292

7 - MAINTENANCE
INITIAL 100 HOURS
Final drive oil (track models)
Change the final track drive gear oil after the initial 100 h of operation and then every 500 h of operation.
Final track drive gear oil specification – T
UTELA
H
YPOIDE
EP G
EAR LUBE
SAE 80W-90
To change oil
1. Position the final drive hub so that one of the drain plugs
(2) is in the 6:00 position as shown.
2. Remove drain plug (2) and let oil drain completely be-
fore replacing the drain plug.
RAIL15SSL0358AA
1
3. Rotate the hub so one drain plug (1) is at the 12:00
position and the other plug (2) is at 3:00 or 9:00 position
as shown.
4. Using a funnel, fill the track drive hub until oil starts to
flow from (2) that is at 3:00 or 9:00 position.
5. Insert both plugs (1) and (2) and wipe any excess or
spilled oil and repeat this procedure on the other side
of the machine.
RAIL15SSL0359AA
2
Capacity - each side 1.0 L ( 1.06 US qt ) +/- 0.1 L ( 0.1 US qt )
Specifications T
UTELA
H
YPOIDE
EP G
EAR LUBE
SAE 80W-90
To check oil level
1. To check the final drive oil level, rotate the hub so one
drain plug (1) is at the 12:00 position and the other plug
(2) is at 3:00 or 9:00 position as shown.
2. Remove the drain plug (2) . If the oil level is at the proper
level, the oil should be even with the bottom of the drain
plug.
3. If the oil is low, remove the top plug (1) and add oil until
it starts to flow out of (2) .
RAIL15SSL0359AA
3
7-46