Master SEL mode on the CONTROL ROOM MONITOR Section
To Enter and Exit Master SEL Mode
u
Press and hold down
LOCK
on the Main Monitor Panel, then press
RTE
SEL
to enter Master SEL mode.
The
RTE SEL
button will flash, along with all of the console
SEL
leds.
Most of the Monitor Panels buttons will have their functionality blocked
out, apart from those indicated in white, left.
Once Master SEL Mode has been switched on, it switches the
DAW
,
EQ
and
DYN
screen over to the Settings Screen display and suspends the
operation of all the buttons
on the Control Room Monitor panel, apart from (shown in white, left):
. 8T
•
2T
•
ST
•
MONO
•
CUT
•
Individual Loudspeaker Cuts
•
The Monitor Pot push-switch
•
A
,
B
,
M1
&
M2
The rest of the Control Room Monitoring panel's button display and
functionality - plus the ability to swap the control room monitoring - is
suspended.
(If lit, the
D-EXT
,
AFL/PFL
&
RTB
leds will also be suspended).
u
Make any desired changes.
u
Press
RTE SEL
again to exit Master SEL Mode.
Any changes you have made will be saved, and the buttons, display
screen and audio will revert to their last selection.
To Tie a Set of Speakers to the Stereo DownMix
It is possible to tie a set of loudspeakers to monitoring the Stereo
DownMix, so that selecting the speaker set, automatically monitors the
Stereo DownMix
u
Press and hold down
LOCK
on the Main Monitor Panel, then press
RTE
SEL
to enter Master SEL mode.
The
RTE SEL
button will flash, along with all of the console
SEL
leds.
Most of the Monitor Panels buttons will have their functionality blocked
out, apart from those indicated in white, left.
u
Press
ST
(the
RTE SEL
and
ST
buttons will flash).
u
Turn the Monitor Knob. The display will show
SUB.
u
Press the Monitor Knob, and a
P
(or a
X
) will be displayed in the last
position of the alpha display, indicating that Sub is (or is not) fed to the
Stereo Mix.
u
Subsequent turns of the knob will display
A
,
B
,
M1
and
M2
.
For each of these displays, pushing the knob will display either a
P
or a
X
to indicate that the stereo downmix is tied / not tied to that speaker set.
For those speaker sets you have tied to the stereo downmix, pressing
those speaker set buttons will automatically swap the monitoring to the
Stereo DownMix
u
Press
RTE SEL
to exit Master SEL Mode.
- 78 -
