MONITOR Section
LCR Pan
Pan control with a 4dB centre-line pan with S-law shaping. The adjacent
LED will light yellow if it is set to work as a conventional L/R pan, or red if
set to work as an LCR Pan (as set in the Routing Screen).
u
Press to enable.
Mon Level Control
Sets the monitor input level, and has a range of -∞ to +10dB.
The push switch function is used by the Encore Automation on the
Genesys console, it is not used on Genesys Black.
AUT
LED
This LED is used by the Encore Automation on the Genesys console, it is
not used on Genesys Black.
DAW
u
Press to toggle the Monitor input between the DAW
SND
and
RET
inputs.
I/P 2
Select a seperate monitor path from the channel DAW return,
I/P2
(or
DMON
when the digital board is fitted) to create more mix inputs.
•
The LED will be
On
when the second inputs (
I/P2
) are selected.
•
The LED will be
Off
when
DMON
is On.
CH
Allows you to send the Channel input to the monitor input, and is a 3-
state toggle switch.
•
Press to listen to the
Channel
input
Post
-fader (LED lights red)
•
Press to listen to the
Channel
input
Pre
-fader (LED lights green)
•
Press to return to the
Monitor
path (LED off)
ISO
Isolates the Channel path, Monitor path (or both) from the Solo system.
When other Solos are detected on the console, a
CUT
will not be applied
to any path that has been isolated.
•
For any path
not
in
ISO,
the
CUT
will be destructive (and
therefore affect the Mix output)
•
For any path
in
ISO, the
CUT
will be safe (and only affect the
monitoring by using the
AFL
buss), and the Solo will act as an
AFL.
It has a 4-state toggle, each state indicated by the adjacent LED:
•
Off
: Both the Channel and Monitor path are part of their Solo
system.
•
Red
: The Channel path is isolated from the Solo system.
•
Green
: The Monitor path is isolated from the Solo system
•
Yellow
: Both the Channel and Monitor paths are isolated from
their Solo systems.
- 51 -
