neuroConn DC-Stimulator, User Manual, Page: 52 / 85

Chapter 5 - Software Reference Manual
52
Signal tone
The DC- STIMULATOR can give out an acoustic warning signal in case of the following
events:
- when you switch the device on
- when you set implausible stimulation parameters
- when you enable / disable the study mode
- when the DC- STIMULATOR is switched on and not used for more than one minute
The speaker symbol in the third line informs you about the current status
of the signal tone. If the speaker symbol is filled, the signal tone is
enabled. If the speaker is unfilled, the signal tone is disabled.
To change the settings of the signal tone please follow these instructions:
- Press button 2 or 4 to select main menu SYSTEM. Move the cursor to line 2 on the
display by pressing button 3.
- Switch to submenu signal tone by pressing button 2 or 4 several times. Move the cursor
to line 4 on the display by pressing button 3.
- Press button 2 or 4 to enable / disable the signal tone.
- Press button 1 several times to move the cursor back to line 1 (the main menu).
Backlight brightness
Backlight brightness can be adjusted in the submenu "backlight brightness".
To change the settings of the backlight brightness please follow these instructions:
- Press button 2 or 4 to select main menu SYSTEM. Move the cursor to line 2 on the
display by pressing button 3.