37
Cal Pedal Toe
This screen allows you to calibrate the maximum or “toe down” setting
on the expression pedal to 100%. To perform the calibration, set the
expression pedal to the toe down position and press the bottom knob.
Cal Pedal Middle
Volume pedals typically have an audio-taper sweep, which changes
slowly in the lower portion of the sweep, then quickly in the upper portion.
ILLUMINE will compensate for this sweep, making it appear like a linear
expression pedal. This screen allows you to calibrate the middle point of
the sweep for a more accurate conversion.
If your volume pedal has a selection switch for the taper: set the treadle to
the middle position and select the switch position that results in the higher
expression value on the screen.
By default, ILLUMINE is calibrated for an Ernie Ball VP-JR with the taper
switch in the up position.
There are two methods to calibrate your pedal:
• Easy but less accurate — set the volume pedal’s treadle to the
halfway point between heel down and toe down. Press the
bottom knob.
• Difficult but more accurate — slowly sweep the volume pedal
while watching the change in expression value. You will notice a
breakpoint at which the value changes accelerate. This value is
typically around 15-25%. Set the treadle to this breakpoint and
press the bottom knob.
CALIBRATE
C
Cal
al Pedal Toe
Pedal Toe
100
100 %
%
Summary of Contents for Illumine
Page 1: ...ILLUMINE REVERB USER GUIDE v 1 0 1...
Page 57: ...neunaber net...
