Neumo AWH TANKO SF40, Operating & Installation Instructions Manual

Page: 51 / 72

Spate cleaner TANKO-SF
7 Maintenance Translation of the original Operating / Installation Instructions 2016/09 Rev.1 43/63
P
oint
Inspection and Maintenance Work
Inter
va
l
M
etho
d
A
Check inlet openings for the cleaning agent and running surfaces for
contaminations, wear and damage.
 Clean in the event of contaminations
 Replace device in the event of wear or damage
500 h
O
S/F/R
B
Check whether the cage rotates freely.
Check outlet openings for the cleaning agent and running surfaces for
contaminations, wear and damage.
 Clean in the event of contaminations
 Replace device in the event of wear or damage
500 h
O
S/F/R
C
Check running surfaces for contaminations, wear and damage.
 Clean in the event of contaminations
 Replace device in the event of wear or damage
500 h
O
S/F/R
D Replace O-ring with original part 500 h
O
---
E Replace wire locking pin with original part. 500 h
O
---
Table 7.4-1: Inspection and Maintenance Work
NOTE
Multiple utilization of the wire locking pin.
The material experiences fatigue and loses its rigidity when the wire locking pin is subjected to multiple
bending. The nozzle carrier may come loose.
The device and the wire locking pin could fall into the container.
 The wire locking pin is to be replaced by a new wire locking pin after it has been bent
(see
section 7.5.1 Spare Parts ).