SDI-EO-2 /SDI-EO-2-RC
Rev. 2
4
Connector module
The SDI-EO-2 / SDI-EO-2-RC has a dedicated connector module: HD-EO-2-C1.
This module is mounted at the rear of the frame. The module is shown in the
figure below.
Figure 3: Connector module for SDI-EO-2.
In typical use, a SDI-EO-2(-RC) / SDI-OE-2(-RC) module at each end will be
used. Two channels can simultaneously be converted from optical to electrical
channels. The electrical input signal is connected to the INx input on the
transmitting SDI-EO-2(-RC), and the electrical output is connected to the
corresponding OUTx+ or OUTx- output BNC on the receiving SDI-OE-2(-RC).
The fibre cable is connected to the corresponding optical port (OPT1 uses
IN1/OUT1- and OUT1+ and OPT2 uses IN2/OUT2- and OUT2+).
4.1
Mounting the connector module
The details of how the connector module is mounted, is found in the user
manual for the Flashlink frame FR-2RU-10-2.
This manual is also available from our web site:
http://www.network-electronics.com/
9