SDI-EO-2 /SDI-EO-2-RC
Rev. 2
3
Format configuration
The SDI-EO-2 can support a number of different broadcast formats. The
correct configuration can either be set with DIP switch or with the GYDA-SC
System Controller. The layout of SDI-EO-2 is shown in the drawing below with
the DIP switch to the upper left position.
Figure 2: SDI-EO-2 board layout.
DIP switch configuration must be set according to the table below:
Switch # Label Function, DIP = ON Function, DIP = OFF
Comment
1
RCL1 Reclocker 1 ON
Reclocker 1 OFF
RC version only
2 EQ1
Automatic
Cable
Equaliser ON
Automatic Cable
Equaliser OFF
Cable equaliser mode
3 ASI1
DVB-ASI
Reclocker
support
SDI 177Mbps Reclocker
support
RC version only
4
RCL2 Reclocker 2 ON
Reclocker 2 OFF
RC version only
5 EQ2
Automatic
Cable
Equaliser ON
Automatic Cable
Equaliser OFF
Cable equaliser mode
6 ASI2
DVB-ASI
Reclocker
support
SDI 177Mbps Reclocker
support
RC version only
7
SWP Normal operation
Swap input 1 and input
2
RC version only
8 OVR
Override
GYDA-SC
control.
Configuaration with
DIP switch
GYDA-SC control.
Configuration with
GYDA-SC
Select configuration
from GYDA-SC
All DIP switches are off when pointing towards the release handle.
The SWP DIP switch sets normal mode(input 1 to output 1 and input 2 to
output 2) or crossed mode (input 1 to output 2 and input 2 to output 1).
GYDA-SC System Controller can set other combinations like duplication of
either input channel to both output channels.
8