Network Electronics ASA Flashlink DA-T140, User Manual

Page: 6 / 16

DA-T140 Rev. 6
3 Configuration
The DA-T140 can support a number of different formats. The correct configuration can
either be set with a DIP switch or with the GYDA Control System. The layout of DA-T140 is
shown in the drawing below with the DIP switch to the upper left position.
Figure 2: DA-T140 board layout.
DIP switch configuration must be set according to the table below:
Switch # Label Function DIP=OFF Function DIP=ON Comment
1 ARB NA NA NA
2 EQM Equaliser forced not to
mute
Automatic muting of
equaliser when signal
strength is too low Input mute
3 RCL NA NA NA
4 EQ Cable equaliser Bypass Cable equaliser ON Equaliser mode
5 ASI NA NA NA
6 SLL NA NA NA
7 BWL NA NA NA
8 OVR GYDA control
Config. with GYDA Override GYDA control
Config. with DIP switch Select GYDA
config. mode
All DIP switches are off when pointing towards the release handle.
network-electronics.com | 6