Page 15 of 51.
Title NetVu Uniplex Desktop NVR Advanced Installation Manual
NetVu Ltd.
No 1 Thellow Heath Park, Northwich Road, Northwich, Cheshire. CW9 6JB
Connecting additional external storage.
Additional external storage can be added to the NVR by connection to the eSATA port on the rear
panel.
Configuring the Unit
Using the Unit with Secure Closed IPTV
The UPXD Desktop NVR has an external power supply unit. Connect the mains lead to the unit and
then to the wall socket, or to a fused spur connection. To be compliant with wiring regulations in
some countries, an Alarm or Security device should be connected to a fused spur and not a wall
outlet socket (check local regulations before installation).
After the NVR has been installed and all connections have been made then power can be
connected.
The recommended power-up sequence is as follows:
1.
Apply power to all NVSE Network Extender Units, this will power cameras, using PoE,
2.
Wait two minutes,
3.
Apply power to UPXD Desktop NVR, wait 5 minutes.
On first time power-up all cameras should be automatically detected and the NVR will start
recording automatically. The factory defaults will be used to dictate the recorded picture quality
and the picture quality for live display.
As a minimum, the following configuration should be done once the system is running:
1.
Set User Names and Passwords,
2.
Set Time and Date,
3.
Configure the Network Settings of the NVR (IP address, Subnet, Gateway).
This can be done using a local monitor with USB mouse and USB keyboard connected to the NVR.
Alternatively, this can be done with browser software and a PC connected to the NVR via a
corporate network port.
The following flowchart shows the recommended process for fully configuring the NVR.
