10
6. Installation
Put on the Waterproof Silicone Sleeve
1. Use the 3M double-sided tape that is provided with the
device. Attach one side of the tape to the bottom of the device
(RB02I) and the other side to the wall. (Please make sure the
surface of the wall is clear and smooth, so the device will not
fall off easily.)
To make the installation more secure, use self-purchased
screws to secure the device to the wall.
*Please wipe and clean the surface of the wall before using the
double-sided tape.
The 3M double-sided tape is pre-cut with the size of the
bottom of the device (as shown in the left photo below.)
Please keep the device from metals or other electronics so the
transmission of the device will not be affected.
Applicable use cases for RB02I wireless emergency push
button include but are not limited to the following:
Home (bathrooms)
Schools
Nursing homes
Hospitals
Banks
Hotels
2. Insert the batteries in the battery holder and put the upper
cover back. Put on the included waterproof silicone sleeve to
avoid water splashing as shown in picture on the right.
*To open the device, use the snap-fit joint and gently remove
the upper cover.
3.
When the emergency button is pressed, it will send an
"alarm" report.
If the emergency and alarm is disarmed when it comes to
the regular report interval, the device will send a "normal"
status report.
*The "alarm" report will be "1" and the “normal” report
will be "0."
