5
4.Set up Instruction
4.1
Power on and Turn on / off
(1)
Power on:
Insert batteries: open the battery cover; insert two sections of 3.6V ER14505 AA
batteries and close the battery cover.
(2)
Turn on
: if the device had never joined in any network or at factory setting mode, after powering
on, the device is at off mode by default setting. Press and hold function key for 3 seconds till the
green indicator flashes once and release to turn on device.
(3)
Turn off:
Press and hold function key for 5 seconds till the green indicator flashes quickly and
release. The green indicator will flash 20 times to show that the device is turned off.
Note:
1.
The interval between shutting down twice or power off/on is suggested to be about 10
seconds to avoid the interference of capacitor inductance and other energy storage
components.
2.
Do not press function key and insert batteries in the same time, otherwise, it will enter
engineer testing mode.
3. Turn off operation is same with “Restore to Factory Setting” operation.
4.2 Join Into LoRa Network
To join the device into LoRa network to communicate with LoRa gateway.
The network operation is as following:
(1)
If the device had never joined any network, turn on the device; it will search an available LoRa
network to join. The green indicator will stay on for 5 seconds to show it joins into the network,
otherwise, the green indicator will be off.
(2)
If R718IJK had been joined into a LoRa network, remove and insert the batteries;
it will repeat step (1).
4.3 Function Key
(1)
Press and hold function key for 5 seconds to reset to factory setting. After restoring to
factory setting successfully, the green indicator will flashes quickly 20 times.
(2)
Press function key to turn on the device which is in the network and the green indicator will flash
once and the device will send a data report.
